Shipping is extra
Shipping is calculated by size and weight in the check out section when you enter your address. Shipping starts from approx $7.50 and is in addition to the product prices shown.

Ford Windsor V8 Bolt Kit - Intake manifold [Kustom Bitz]

Overall Rating :
Small block Ford 289, 302, 351 Polished Stainless Bolts - Socket Caps
$92.97
Qty
 
 

Product Description
Part# FDW-INT-KBSktCap - Small Block Ford Inlet Manifold Bolt Kit. This bolt kit will not rust up like chrome bolts can. This socket cap head bolt kit is from our standard range of 316 polished stainless steel bolts polished to our KustomBitz standard finish. These are the bolts that have the Allen Key hex type slot in a round headed bolt with a gnarled outer edge. This custom inlet manifold bolt kit will suit early small block Ford Windsor 289, 302, 351 V8 engines. This bolt kit comes complete with 12 x manifold bolts, 2 x water neck bolts, 2 x bolts for the standard accessory holes, washers and spring washers, so you get everything you need to do a typical Windsor inlet manifold. Will suit most small block Ford standard production cast iron manifolds, dual plane and single plane after market Aluminium [Aluminum for our USA friends] manifolds.

Installation - with inlet manifolds on V8s we recommend that you install your polished stainless bolts after your engine has been started and you have run it up to full temperature. So use your standard engine bolts at first to hold the correct torque tension on the inlet manifold gaskets until they are stuck for good on the first few runs. Then install your stainless steel bolts one by one and torque them to half of the standard torque setting so you do not snap them off.  All Kustom Bits bolts we supply are an A4-70 grade stainless bolt which is slightly less in tensile strength than the standard grade 5 engine bolts for your inlet manifold.  We make this recommendation so that your intake manifold gaskets seal and settle properly to ensure you have no problems.  Those of you who run turbochargers or superchargers you should not run stainless bolts on an engine with high inlet manifold pressures and high tension loads on the blower snout from the belt and pulley drive, we recommend you use the ARP high tensile strength race engine black bolts only.



Your basket is empty
Currency
There is More to see
Keyboard page down or scroll bar on right of screen to view more product, text & pictures.
Please click here to sign in or register.
We accept Pay Pal

About Secure Payment

Gift Certificates

TRADE & DEALER inquiries welcome
All our bolt kits are available for resale. We can tailor & package a bolt kit in Polished Stainless or high tensile steel to your requirements in small or large quantities.
 
#1 Bulk stocker & supplier to the trade, & retail outlets, of AussieSpeed Products

 

Product Photos
All Kustom Bitz web site product photos are of the actual part and not a studio enhanced up image. We keep it real.
Mobile Phone Scan Code

 
KustomBitz
Contact Details

 
Kustom Bitz
Address Details